WSERD30-B 1/30C MOTOR GUIDE
Protection index: IP20
The motor can be compatible with 15 remotes at most
Received frequency: 433.92MHz
Charging: 5V/1A Type C
Working Temp: -10°C to 60°C
Charge Time: 5-6 hours
CHARGING & WAKING UP MOTOR
Please charge the motor using charger 5V/1A before operation. The motor won't function until it has been charged.
Waking up the motor for the first time:
Method A - Plug 5V/1A charger into charging port for a few seconds until it vibrates.
Method B - Short press program button 5 times and release, the LED light turns green, and the motor vibrates.
PAIR REMOTE TO MOTOR
CHANGING THE RUNNING DIRECTION
TURN ON "STEP-BY-STEP" MODE (the motor will move in small increments per remote's button press)
TURN OFF "STEP-BY-STEP" MODE (motor will operate normally)
TOP LIMIT SETTING
BOTTOM LIMIT SETTING
TOP LIMIT DELETING
BOTTOM LIMIT DELETING
ASSIGNING AN ADDITIONAL REMOTE
SETTING THE THIRD LIMIT
THE LIGHT INDICATOR
SPEED ADJUSTMENT VIA REMOTE
USING MOTOR PROGRAM BUTTON TO CONTROL BLIND
SLEEP MODE & RESET
In order to save battery, the motor is in sleep mode as default. Short press program button 5 times, the indicator light will turn green, or charge the motor for a few seconds till it vibrates. Both methods will wake up the motor.
To set the motor to sleep mode, short press program button 5 times. The indicator light will flash red, or charge the motor for a few seconds till it vibrates. Both methods will set the motor to sleep mode.
Pressing and holding the program button for 10 seconds will delete all settings, you can then reset the motor.
In order to keep product in good condition, please charge the motor every 3 months.
Don’t put the product into or near fire.
Settings may fail due to radio interference. In this case, please reset.
Remote RE101 is taken as an example in this guide. The motor is compatible with several Alpha remotes.
Please do not press buttons for too long unless instructed otherwise. Each pressing is about half a second with 1 sec intervals.
If the remote’s battery is low, it may fail to control the motor. Please replace battery immediately.
Please do not let children play with the remote or motor.
Storage temperature: -20°C to 65°C
This information is subject to changes without prior notice.