WALL MOUNT RE601i-602i REMOTES
Working Temperature: -20℃ to +60℃
FOR SINGLE CHANNEL: Make the motor at learning state (refer to motor’s user manual), press remote’s UP and DOWN buttons simultaneously once, then short press STOP button once, the motor vibrates, the remote is paired to the motor.
Example: RE602 series could set four Channels, each channel with corresponding button and light.
a) During Sleep Mode (all lights are off), press any one switch button once, could check which channel have been set (corresponding light will shine).
b) During channel checking (channel light are on), press the channel switch button again. If the channel hasn’t ever been set, it will be set now, if the channel have ever been set, it will be deleted now and the corresponding light off.
After code learning and UP & DOWN limit set, press the left buttons
25%, 50%, 75%, could control the percentage.
If you need set group control, you have to add or delete channels within 3-4s after checking channel.
Only after code learning and limits are set, you can control the percentage.
You’d better not press the remote’s buttons too long so as to prolong the battery.
The button press should be about 0.5s with 1s interval.
The remote will stop working if the battery is in low power. Please replace the battery in this case.